ECS Tuning Driveshaft Center Support - B8 A4/S4/A5/S5/RS5 DSG

Automatic / DSG Transmission B8 A4/S4/A5/S5/RS5

As our beloved B8s age the stock center support bearing starts to wear out causing drivetrain clunk. The factory bearing carrier is not serviceable in stock form. There are two ways to refresh this bushing, buy a completely new driveshaft or cut the stock center support bearing off and replace it with our upgraded ECS polyurethane one. 

Features:

• Key benefits:

  • Allows replacement of center support bearing housing to be replaced without full driveshaft replacement

  • No driveshaft removal required

• Design:

  • Clamps on over existing center support bearing

  • Fully replaces worn out rubber that allows for excessive driveshaft movement

  • Billet 6061-T6 aluminum housing with type II black anodized finish

  • Polyurethane bearing retainer to provide support and minimize NVH 

  • All hardware and loctite provided with our kit for installation

  • Retains factory mounting location and exhaust clearance