GO

VIS Motorsport High Pressure Fuel Pump Internals - 2.0T FSI EA113 (Big Turbo Version - 600hp+)

icon Share icon Share
0 review Write a Review
SKU:
Shipping: Calculated at Checkout
SKU: VIS006
quickcode: AKS-VISEA113S2
part: Engine
SubPart: Engine Tuning
£435.00

VIS Motorsport High Pressure Fuel Pump Internals - 2.0T FSI EA113 (Big Turbo Version - 600hp+)

£435.00
Choose Options

VIS Motorsport High Pressure Fuel Pump Internals - 2.0T FSI EA113 (Big Turbo Version - 600hp+)

£435.00

VIS Motorsport HPFP Internals - 2.0T FSI EA113 (Big Turbo Version - 600hp+)
This version is not required; nor suitable for vehicles running any less than 600+ BHP. 

Modification of the 2.0T-FSI EA113 to Stage 2+ or above required additional volume of high-pressure fuel in order to eliminate 'fuel cut', especially in the mid-range.  

The limitation of how much volume of fuel the high pressure pump can flow is dependent upon the volume displaced by the pressurizing cylinder inside the pump.
This upgrade replaces the internal parts that are responsible for pressure and volume of fuel that reaches your injectors to meet the demands that come with higher power levels.

Tolerances involved, the final surface finish on the piston inside the fuel pump is so critical that it can be damaged by touching them with bare hands.
The tolerances between the piston and the new sleeve the piston rides in can only be measured by a machine which uses air volumes to measure the part clearances to within microscopic levels.​

Features: 

  • Piston has 75% more area over the OEM
  • Piston head optimized for ideal fuel flow direction
  • Piston surface hardened and heat treated in 3 different stages
  • Uses OEM-style spring keeper, not a higher rated one that will prematurely wear the cam follower
  • Get the most out of the direct injection fuelling system on your 2.0T FSI. Not only does the upgrade increase the amount of fuel your high pressure fuel pump can deliver but it will also decrease the duty cycle of the N276 solenoid on your pump. Lowering the duty cycle of the N276 will extend the life of this solenoid, an item that commonly fails on these pumps but isn't available separately.
  • Even a standard stock or Stage 1 car will see benefits from running these internals
  • Can sustain easy 600 hp, over 175 bar if hardware setup allow!
  • Laser marked for better traceability and protecting from fake replica
  • Pump housing O ring made of Viton
  • Each HPFP internal kit is sold as a rebuild kit only(not complete unit),but you send us your pump. We’ll inspect it, rebuild it, test it, and ship it back if you are not able to install! Either you can choose from our new complete units.

THIS ITEM IS A SPECIAL ORDER AND IS EXCLUDED FROM OUR STANDARD RETURNS POLICY
DO NOT ORDER THIS KIT UNLESS YOUR VEHICLE IS RUNNING 600HP OR MORE

  • Shop By Car/Audi/A3 (8P 03-13)/Engine Tuning
  • Shop By Car/Audi/A4 (B7)
  • Shop By Car/Audi/S3 (8P)/Engine Tuning
  • Shop By Car/Audi/TT Mk2 (8J)
  • Shop By Car/SEAT/CUPRA/Altea
  • Shop By Car/SEAT/CUPRA/Leon Mk2 (1P)
  • Shop By Car/SEAT/CUPRA/Toledo Mk3 (5P)
  • Shop By Car/Skoda/Octavia Mk2 (1Z)/Engine Tuning
  • Engine/Tuning

Customers Also Viewed